Tamarack Solar 3.1 Rail Splice (+ 2 bolts and ch nuts) - 6 Pack

Feature Bullets

• The Tamarack Ground Mount System is assembled using 3.1 rail with 2 in schedule 40 or 80 galvanized steel pipe that is purchased separately
• Use four 66-inch rails and two structural splices per column to create two 132-inch rail assemblies for 3 modules per column
• Use four 85-inch rails and two structural splices per column to create two 170-inch rail assemblies for 4 modules per column
• The maximum PV module width is 41.5- inches on 4 module columns and 43 inches on 3 module columns
• The system comes with all parts needed except for the 2-inch pipe and concrete. Assembly is quick and easy and can be used on almost any terrain
• Simple design - arrays can be in columns of 3 or 4 module high and any width required
• Easy to install - no welding or drilling and two wrench sizes fit all fasteners
• UL 2703 listed - all components meet the ul 2703 standards for bonding and grounding
• PE Certified - Pre-stamped engineering letters available for most states
• Easy to configure - Unlimited system size with tilt angles from 0 to 45 degrees
• Visually appealing - Simple to adjust for perfect alignment, even if the surface is irregular
• Simple wire management - PV cables and wiring for module-level electronics fits inside rails to avoid time-consuming wire management
• Extremely robust - For use in locations with wind speeds up to 170 MPH and ground snow loads of up to 70 PSF

Specifications:

Suitable For Use With: 3.1 Rail
Includes: 2 Bolts, Channel Nuts
Standards: CE, ETL, IEC, UL Listed
Warranty: 25 Years
Weight: 6.5 lb