Sol-Ark 15 kw Battery/Battery-Less Inverter
200A passthrough, so there's no subpanel needed! This inverter is perfect for whole-home backup. Features and benefits include parallel stacking, grid sell, meter zero, time of use, smart load, AC coupling, & peak shaving. The Sol-Ark 15k Outdoor Case is a pre-wired system that contains the inverter, charge controller, and more, all in one package; no fuses, breakers, or combiner boxes necessary! With minimal additional hardware required, your install stays simple and low-cost. Sol-Ark inverters also do not have expensive battery restrictions like other solar inverters do, and can be used with a wide variety of 48V battery chemistries, from lead to lithium.
Feature Bullets
- French cleat for easy installation
- Built-in solar array disconnect
- Remote Wi-Fi/Ethernet and local monitoring
- Outdoor rated NEMA 3R
- Battery agnostic
- 19.5 kW Solar input power
- 15 kW Output power off-grid
- Full generator compatibility
Specifications:
Width: 18.3 in
Height: 31.8 in
Depth: 10.9 in
Maximum Allowed PV Power (STC): 19500 W (Input Data PV)
Maximum PV Power Delivered to Battery & AC Outputs: 15000 W (Input Data (PV))
MPPT Voltage Range: 125-425 V (Input Data PV)
Startup Voltage: 125 V (Input Data PV)
Maximum DC Input Voltage: 500 V at 26 A (Input Data PV)
Maximum Operating Input Current Per MPPT: 26 A (Input Data PV)
Number of MPPT Trackers: 2 (Input Data PV)
Number of PV Strings Per MPPT: 3 (Input Data PV)
Maximum AC Coupled Input: 19200 W (Input Data PV)
Battery Chemistry: Lead-Acid or Li-Ion (Battery Input Data DC)
Nominal DC Voltage: 48 V (Battery Input Data DC)
Operating Voltage: 43-63 V (Battery Input Data DC)
Capacity: 50-9900 Ah (Battery Input Data DC)
Maximum Battery Charge/Discharge Current: 275 A (Battery Input Data DC)
Charging Controller: 3-Stage with Equalization (Battery Input Data DC)
Grid to Battery Charging Efficiency: 96% (Battery Input Data DC)
External Battery Temperature Sensor (BTS): Included (Battery Input Data DC)
Current Shunt For Accurate %SOC: Included (Battery Input Data DC)
External Gen Start Based on Voltage or %SOC: Included (Battery Input Data DC)
BMS Communication: CANBus & RS485 (Battery Input Data DC)
Connection: 120/240/208V Split Phase (Output Data AC)
Continuous AC Power with PV: 15000 W 62.5 A-L at 240 V (Output Data AC)
Continuous AC Power from Batteries: 12000 W 50 A-L at 240 V (Output Data AC)
Total Harmonic Distortion (THD): Continuous AC Power with Grid or Generator: 48000 W 200A L-L (240 V), 24000 W 200 A L-N (120 V) (Output Data AC)
Grid Frequency: 50/60 Hz (Output Data AC)
Maximum Output Fault Current (5 sec): 94 A with PV
Maximum Output Fault Current (100 ms): 75 A without PV
Power Factor Output Range: +/-0.9-1 (Output Data AC)
CEC Efficiency: 96.5% (Peak 97.5%) (Output Data AC)
Design (DC to AC): Transformerless (Output Data AC)
Stackable: 12 (Output Data AC)
Idle Consumption Typical-No-Load: 90 W (Output Data (AC))
Sell Back Power Modes: Limited to Household/Fully Grid-Tied (Output Data AC)
Response Time (Grid-Tied to Off-Grid): 5 ms (Output Data AC)
PV DC Disconnect Switch-NEC 240.15: Integrated
Ground Fault Detection-NEC 690.5: Integrated
PV Rapid Shutdown Control-NEC 690.12: Integrated
PV Arc Fault Detection-NEC 690.11: Integrated
PV Input Lightning Protection: Integrated
PV String Input Reverse Polarity Protection: Integrated
AC Output Breaker-200 A: Integrated
200 A x 2 Battery Breaker/Disconnect: Integrated
Surge Protection: DC Type II/AC Type II
Enclosure Rating: IP65/NEMA 3R
Ambient Temperature Rating: -40 to 60 deg C
Mounting Type: Wall
Communication and Monitoring: Wi-Fi & LAN Hardware Included
Standards: Electronics Certified Safety by SGS Labs to NEC & UL Specs - NEC 690.4B & NEC 705.4/6, Grid Sell Back - UL1741-2010/2018, IEEE1547a-2003/2014, FCC 15 cETLus Listed B, UL1741SB, CA Rule 21, HECO Rule 14H
Warranty: 10 Years
Weight: 135 lb
Item Documents Specification Sheet
Item Documents Installation/Operation Manual